Differences

This shows you the differences between two versions of the page.

--- ultimaker_3_extended:ultimaker_3_extended [2020/05/25 10:44] – formlab
+++ ultimaker_3_extended:ultimaker_3_extended [2026/09/11 21:43] (current) – external edit 127.0.0.1
@@ Line 2: / Line 2: @@
 {{:ultimaker_3_extended:ultimaker_3_extended.png?nolink&200|}}
-[[:How much does FDM printing cost?]]
+  * Max Build Volume: ''215 x 215 x 300mm''
+  * [[:Filament options]]
+[[https://www.formlab.schoolofarts.be/pricing|How much does FDM printing cost?]]
+----
 ===== Maintenance =====
@@ Line 28: / Line 33: @@
   * [[https://ultimaker.com/en/resources/52504-clean-the-feeders|Clean feeders]]
   * [[https://ultimaker.com/en/resources/52505-replace-the-bowden-tubes|Replace Bowden tubes]]
+===== Troubleshooting =====
+==== Printer not in remote clusters  ====
+✔ Solved\\
+/04/2026
+When you want to print via cloud you get the message 'printer not in remote clusters'.
+In the browser, go to [[https://digitalfactory.ultimaker.com/|Digital factory]] and remove the printers that you can't print on via the cloud.
+Restart the computer.\\
+Make sure that cura is not open. Then go to the printer.
+On the printer
+  * system > Maintenance > Digital Factory reset. (The printer restarts)
+  * after the restart, go to system > netword > Digital Facotory > Connect to Digital Factory. You'll get a 6 digit code
+(you don't need a firmware upgrade. they are now on 5.3 which is the highest firmware. (Unmaintained, no new firmware updates coming)).
+On the computer, go to [[https://digitalfactory.ultimaker.com/|Digital factory]] again and add a new printer. Select the 'S' printer type and add the code to pair up the printer. The printer shows it's offline, but after a minute or two it changes to the active online status.