Instructions

User Tools

Site Tools

You are here: start » tripodmaker » maintenance
tripodmaker:maintenance

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
tripodmaker:maintenance [2021/04/08 16:53] – [Clean drive gear] formlabtripodmaker:maintenance [2026/09/11 21:43] (current) – external edit 127.0.0.1
Line 47: Line 47:
   * In the print panel of Repetier-Host, **extrude ''2,5''mm** (the speed is not important). This rotates the extruder gear just enough to clean the next section   * In the print panel of Repetier-Host, **extrude ''2,5''mm** (the speed is not important). This rotates the extruder gear just enough to clean the next section
   * Keep cleaning until the whole gear is free from plastic.   * Keep cleaning until the whole gear is free from plastic.
 +
 +{{:tripodmaker:cleaning_extruder_gear_web.jpg?400|}}\\ Easiest entrance for the pick.
tripodmaker/maintenance.1617893607.txt.gz · Last modified: (external edit)